NETGEAR GS110EMX 8-Port SmManaged Plus Gigabit Switch - Manual (Page 78)

Factory Default Settings
You can return the switch to its factory settings. Use the end of a paper clip or some
other similar object to press and hold the
Factory Defaults
button on the front panel
of the switch for four seconds. The switch resets and returns to the factory settings that
are shown in the following table.
Table 6. Factory default settings
Setting Feature
password Switch password
192.168.0.239 (if the switch is not connected to a network with a DHCP server) IP address
255.255.255.0 Subnet mask
Enabled DHCP mode
Enabled UPnP
Enabled Bonjour
Enabled NSDP
Enabled IGMP snooping
None configured LAGs
Disabled. If enabled, by default, all ports are members of VLAN 1. VLANs
Disabled. If enabled, by default, the Class of Service (CoS) value is 6. Voice VLAN
Enabled 802.1p/DSCP-based QoS
Disabled Port-based QoS
Disabled Rate limiting
Disabled Broadcast filtering
Enabled Loop prevention
Disabled Power saving mode
Autonegotiation Port speed
Disabled Flow control
Disabled Port mirroring
User Manual 78 Factory Default Settings and
Technical Specifications
8-Port Gigabit Ethernet Smart Managed Plus Switch Model GS110EMX