NETGEAR GS110EMX 8-Port SmManaged Plus Gigabit Switch - Manual (Page 63)

To manage the port speed and the port status and add a port description:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that
is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
4. Enter the switch password.
The default password is
password
. The password is case-sensitive.
The Switch Information page displays.
5. Select System > Management > Port Status
.
The Port Status page displays.
6. Select one or more ports.
7. In the
Speed
menu, select one of the following options:
•
Auto
. The port speed is set automatically after the switch determines the speed
using autonegotiation with the link partner. This is the default setting.
•
Disable
. The port is shut down.
•
10M Half
. The port is forced to function at 10 Mbps with half duplex.
•
10M Full
. The port is forced to function at 10 Mbps with full duplex.
•
100M Half
. The port is forced to function at 100 Mbps with half duplex.
•
100M Full
. The port is forced to function at 100 Mbps with full duplex.
Ports 9 and 10 do not support 10 Mbps half duplex, 10 Mbps full duplex, or 100
Mbps half duplex.
8. If you selected a single port in Step 6, to add a port description, enter a text in the
Port Description
field in the table heading.
If you selected more than one port in Step 6, you cannot add a port description.
9. To configure more ports, repeat this procedure from Step 6 on.
10. Click the Apply
button.
Your settings are saved.
User Manual 63 Manage and Monitor the Switch
8-Port Gigabit Ethernet Smart Managed Plus Switch Model GS110EMX