Kodak S3060 Document Scanner - Manual (Page 17)

A-61981 20 April 2022 9
2 Installation/First Scan
Installation
The following is a list of steps you will need to perform in order to get
your scanner set up and connected to your computer.
1. Unbox your scanner.
2. Set up your scanner for the first time.
3. Install driver software.
4. Verify the scanner’s firmware.
5. Optionally update the scanner’s firmware.
6. Optionally install available Alaris scanning software.
NOTES:
• When installing updates, update the driver software before updating the
scanner’s firmware.
• If you have already performed all of the steps in the Installation Guide skip
this section.
Unboxing the scanner Follow these steps to unbox your scanner and get it ready to set up.
1. Open the scanner box.
2. Remove all the contents from the scanner box.
3. Remove all the shipping tape and packing material from the scanner.
4. Find the
Installation Guide and open it.
5. Verify the contents of the scanner box. (Refer to the left panel of the
Installation Guide .)
NOTE: When positioning the scanner, be sure to provide adequate clearance
at the back of the scanner if you will be using the rear document exit or
the Kodak Printer Accessory.