Elektron Analog Heat + FX Hybrid Digital/Analog Sound Processor - Manual (Page 14)

5. INTERACTING WITH THE ANALOG HEAT +FX
14
5.4 FILTER TYPES
Change the type of the filter by pressing one of the two [FILTER TYPE] keys. You can also press the two
[FILTER TYPE] keys simultaneously to toggle the filter on/off. It is possible to change the filter type even if
the filter is turned off.
There are seven different analog filter types in the Analog Heat +FX to help to shape the sound.
•
LOW PASS 2 (two-pole, 12 dB per octave)
• LOW PASS 1 (one-pole, 6 dB per octave)
• BAND PASS
• HIGH PASS 1 (one-pole, 6 dB per octave)
• HIGH PASS 2 (two-pole, 12 dB per octave)
• BAND STOP (NOTCH)
• PEAK
5.5 EQUALIZER
LOW and HIGH adjust the amount of low-end and high-end frequency gain or attenuation of the effect
circuit. Each character circuit comes with its tailor-made equalizer characteristics. For more information,
please see “4.1 AUDIO SIGNAL FLOW” on page 12.
5.6 DRIVE
DRIVE sets the gain level in the effect circuit. A higher setting increases the effect of the selected circuit type,
typically resulting in more distortion. For more information, please see “4.1 AUDIO SIGNAL FLOW” on page
12.
5.7 LEVEL
LEVEL sets the level of the signal coming from the effect. It is applied before the dry/wet mix set by MIX . It
is used to match the level of the dry signal for easy mixing of the two. For more information, please see “4.1
AUDIO SIGNAL FLOW” on page 12.
5.8 MIX
MIX sets the mix between the clean (dry) signal and the signal that is affected by the effect (wet). For more
information, please see “4.1 AUDIO SIGNAL FLOW” on page 12.
5.9 SETTINGS MENU
Press [SETTINGS] to access the SETTINGS menu.
Scroll through the list of settings by using the NAVIGATION knob. Open a highlighted menu by pressing the
NAVIGATION knob or [YES] . To change the settings in the menus, first press, and then turn the NAVIGA-
TION knob. For more information, please see “6. THE SETTINGS MENU” on page 17.
5.10 PARAMETER PAGES
Press a [PARAMETER] page key to access the corresponding parameter pages [FLOW] , [HEAT] , [FX] ,
and [MOD] . There are usually several parameter pages associated with each key. You access these pages
by turning the NAVIGATION knob.. For more information, please see “7. PARAMETER PAGES” on page 25.
5.11 PARAMETER EDITING
The four DATA ENTRY knobs are used to set the parameter values that you see on the screen. (Some
parameters also have dedicated knobs on the panel.) The physical location of the knobs on the front panel
corresponds to the layout of the parameters on the screen.