6 bass focus – Elektron Analog Heat + FX Hybrid Digital/Analog Sound Processor User Manual

Page 29

Advertising
background image

7. PARAMETER PAGES

29

THR

Threshold sets the threshold of the compressor. A lower threshold means a larger portion of the

signal is subject to compression.

ATK

Attack sets the time of the compressor attack phase, i.e. how quickly the compressor responds

to loud peaks.

REL

Release sets the time of the compressor release phase, i.e. how long it takes for the compression

to recover in quieter moments.

MUP

Makeup Gain sets the makeup gain of the compressor output, to compensate for the reduced

signal levels caused by compression. The Makeup Gain parameter value is displayed in dB.

7.3.5 COMPRESSOR PAGE 2

RATIO

Compression Ratio. There are eight different compression ratios, 1.50, 2.00, 3.00, 4.00, 6.00,

8.00, 16.00 and 20.00. Higher ratios result in greater compression of the signal.

SC FLTR

Sidechain Filter filters the audio signal before the compressor analyzes it. The parameter

ranges from a low-pass filter to a high-pass filter. Negative parameter values sets a low-pass filer.

Positive parameter values sets a high-pass filter.
When set as a low-pass filter, the compressor reacts mostly to bass frequencies. Use this setting for a

characteristic pumping compressor sound. When set as a high-pass filter, the compressor reacts less

to bass frequencies. Use this setting to avoid pumping.

MIX

Sets the mix between the clean signal and the signal that is affected by the effect.

The Analog Heat + FX compressor

Filter

(HP/LP)

Gain

Reduction

Input

(LR)

Output

Control

Signal

Dry/Wet

Mix

Make up

Gain

Gain

Computer

Dynamics

(Atk/Rel)

7.3.6 BASS FOCUS

This FX block can be used to detect and correct any stereo phase problems in the low-end register of

the signal. It uses a crossover filter to divide the signal into a low band and a high band, allowing you to

make the low band part of the signal mono. You can also attenuate the two bands separately. The -1 to

1 meter displays the amount of phasing in the low band. A positive value means that the signal does not

Advertising