Elektron Analog Heat + FX Hybrid Digital/Analog Sound Processor - Manual (Page 21)

6. THE SETTINGS MENU
21
Using a USB audio host together with Analog Heat +FX opens up several interesting possi-
bilities of how to use the Analog Heat +FX. Here are some examples and how the ANALOG
IN/OUT and USB CC MODE parameters should be set to achieve them:
• Analog Heat +FX as an insert effect for the USB audio host:
ANALOG IN/OUT: IN+OUT, USB CC MODE: INSERT
• USB audio host as a pre-Analog Heat +FX insert effect:
ANALOG IN/OUT: OUT, USB CC MODE: PRE
• USB audio host as a post-Analog Heat +FX insert effect:
ANALOG IN/OUT: IN, USB CC MODE: POST
• Analog Heat +FX as a transparent sound card for the USB audio host:
ANALOG IN/OUT: OFF, USB CC MODE: BYPASS
6.5.4 USB TO MAIN
Sets the gain level of the audio sent from the USB audio host to the Analog Heat +FX. This setting only
affects the audio sent from the USB audio host to the analog OUTPUT L/R and HEADPHONES out-
puts. This parameter is only available if USB AUDIO+MIDI or OVERBRIDGE mode is chosen in the USB
CONFIG menu, and if it is included in the audio routing chosen in USB CC MODE . For more information,
please see “6.8.1 USB CONFIG” on page 23. (0 dB–+18 dB)
6.6 MIDI CONFIG
These settings are stored in the global settings and are not part of the preset.
6.6.1 SYNC
• CLOCK RECEIVE
Sets whether or not the Analog Heat +FX responds to MIDI clock and transport sent from external
devices. (ON, OFF)
• CLOCK SEND
Sets whether or not the Analog Heat +FX sends/forwards MIDI Clock and transport. Transport is
transmitted when an external clock source (MIDI or Overbridge) is used. (ON, OFF)
• PROG CHG RECEIVE
Sets whether or not the Analog Heat +FX responds to incoming program change messages. This
is useful when wanting to select presets from an external source. For more information on how to
select the appropriate MIDI channel, please see “6.6.3 CHANNELS” on page 22. (ON, OFF)
• PROG CHG SND
Sets whether or not the Analog Heat +FX sends program change messages when it changes
patches. For more information on how to select the appropriate MIDI channel, please see “6.6.3
CHANNELS” on page 22. (ON, OFF)
6.6.2 PORT CONFIG
• TURBO SPEED
This setting allows Turbo mode negotiation between Elektron gear. Connecting the Analog Heat
+FX to other Turbo protocol compatible gear, like the Analog Rytm and the Octatrack, makes it
possible to increase the average MIDI bandwidth by up to 10x. This increases the accuracy of MIDI
clock signals as well as the timing of CC messages. (ON, OFF)
• OUT PORT FUNC
Sets what type of signal the MIDI OUT port sends.
• MIDI sets the port to send MIDI data.
• DIN24 sets the port to send DIN 24 sync pulses. No MIDI data can be sent on the port when this
option is selected.
• DIN48 sets the port to send DIN 48 sync pulses. No MIDI data can be sent on the port when this
option is selected.