Elektron Analog Heat + FX Hybrid Digital/Analog Sound Processor - Manual (Page 22)

6. THE SETTINGS MENU
22
• THRU PORT FUNC
Sets what type of signal the MIDI THRU port sends. The settings are the same as for OUT PORT
FUNC .
• INPUT FROM
Sets the source from which the Analog Heat +FX receives MIDI data.
• MIDI Only receives MIDI data from the MIDI IN port.
• USB Only receives MIDI data from the USB port.
• MIDI+USB Receives MIDI data from both the MIDI IN and USB port.
• NONE Disregards any incoming MIDI data.
• OUTPUT TO
Selects the port to which Analog Heat +FX sends MIDI data (CC or NRPN).
• MIDI Only sends MIDI data to the MIDI OUT port.
• USB Only sends MIDI data to the USB port.
• MIDI+USB Sends MIDI data to both the MIDI OUT and USB port.
• NONE Do not send MIDI data to any port.
• PARAM OUTPUT
Sets what type of MIDI messages the DATA ENTRY knobs sends. For information about which CC/
NRPN parameters that are sent, please see “APPENDIX A: MIDI” on page 41.
• CC Sets the knobs to send CC MIDI messages.
• NRPN Sets the knobs to send NRPN MIDI messages.
• ENCODER DEST
Sets whether or not the DATA ENTRY and LEVEL knobs send MIDI data.
• I NT MIDI only sends data internally.
• INT + EXT MIDI sends data both internally and externally.
• PARAM INPUT
Makes it possible to control Analog Heat +FX parameters from an external MIDI device sending
CC/NRPN data. (ON, OFF)
6.6.3 CHANNELS
• MIDI CH MAIN
Sets the main MIDI channel that Analog Heat +FX uses to send and receive MIDI data.
• MIDI CH FX
Sets the dedicated MIDI channel that is associated with MIDI CC control of the parameters on the
parameter pages of the digital FX blocks (all FX blocks except the Heat block). However, MIDI
NPRN control uses the channel set by MIDI CH MAIN .
6.7 SYSEX DUMP
In the SYSEX DUMP menu, settings and Presets can be sent and received. Select a menu option using the
NAVIGATION knob. Press [YES] to open the highlighted menu selection.
When receiving or sending SysEx data, the MIDI ports or the USB port of the Analog Heat +FX should be
connected to the external sending/receiving device.
If the Analog Heat +FX is sending or receiving SysEx data through the MIDI ports, use the Elektron TM-1
USB MIDI interface for up to 10x transfer speeds.
Before initiating a SysEx send or receive, first, make sure the receiving device is listening for
data to be sent.