Epson C82362 - Manual (Page 54)

3-4 Using the Interface Card with NetWare
R4C3610 Adm/G
Rev. C
A5 size Chap3.fm
8/4/00 Pass 0
L Proof Sign-off:
KOW M.Arai K.Nishi
K. Nishi
J.Hoadley
You can select either of the following routing protocols; a)
NLSP with RIP/SAP Compatibility or b) RIP/SAP Only. If
you remove the bind of RIP or SAP when NLSP with RIP/
SAP Compatibility is specified, the interface card is not able
to communicate with the file server and NDS. (See
“Protocols” and “Bindings” in NetWare’s INETCFG utility.)
Time required to recognize the interface card
It takes up to two minutes for the NetWare server to recognize
the interface card after turning on the printer. During this
start-up time, the status sheet does not show the correct
information.
Frame type
The same frame type should be used for the NetWare server
and IPX router on the same network. If more than one frame
type is used on the same network, bind the all the frame types
to the NetWare servers and IPX routers.
Instruction for NetWare 5
The IPX protocol must be installed (bound) to the NetWare 5
server.
Instruction for mode
If the mode you have logged in is different from the mode you
set for the interface card, a message appears when you try to
configure the interface card for NetWare. If you do not want
to change the current settings, click Cancel and log in again
in the same mode as you set for the interface card.