Epson C82362 - Manual (Page 78)

3-28 Using the Interface Card with NetWare
R4C3610 Adm/G
Rev. C
A5 size Chap3.fm
8/4/00 Pass 0
L Proof Sign-off:
KOW M.Arai K.Nishi
K. Nishi
J.Hoadley
Configuring the interface card using EpsonNet WinAssist
Configure the interface card using EpsonNet WinAssist.
1. Turn on the printer with the interface card installed.
2. From any NetWare client, log in to the target NetWare server
with supervisor privileges or ADMIN.
3. Load the print server from the file server’s system console
which the print queue volume is set.
>LOAD PSERVER PCONSOLE or
>LOAD PSERVER print server name you set using
NWADMIN
4. Run EpsonNet WinAssist from the Start menu.
5. Click IPX. Select the printer you want to configure from the
list, then click Configuration.
Note:
❏ If you have connected more than one printer with the same type
of interface card to the network, you can distinguish between
the cards by the MAC address on the status sheet or the sticker
on the interface card.
❏ If the IP address is set to the default IP address, the printer model
may not appear.