Honeywell 11255 - Manual (Page 17)

17
SA600-G10 Diffusion Media for Air Intake
Models SA600-xxx
For downdrafts and prep stations. This filter pro-
vides the highest level of protection against paint
damaging particles available today. In addition to
its leading reputation in filtering ability, the SA600-
G10 is able to withstand high temperature applica-
tions, up to 140 degrees Celcius! This filter does
not discolor or break down in the heated booth
environment. Other leading media using traditional
tackifiers and PVC resins, produce a heavy discol-
oration and the media expands reducing the filter-
ing ability.
Flanders’ re-engineered media and manufacturing
process has virtually eliminated these flaws. Using
ecologically sound materials, and eliminating PVC
resins, the media discoloration and media expan-
sion have been minimized. The SA600-G10 is a 1”
diffusion media, and carries the prestigious G10
mark. G10 is a European standard for test per-
formance, and only qualified media can claim this
mark of distinction. It has a high dust holding
capacity for long life, and stops all particles of paint
damaging size from entering a paintbooth when
installed properly.
This product has a normal service life of 10 to 18
months, depending on outside air quality and
usage. The filter is available in bulk rolls or cut
pads for your convenience. Cut pads are cut in our
facility to your booth requirements.
SAR-1 Pad for Air Intake
Models SAR1M-xxxxx
For use as an intake blanket on crossdraft booths.
The SAR-1 media, made in Switzerland, has a 1/2“
loft, and is optimally designed for efficiency and
dust holding capacity. For crossdraft booths, the
SAR-1 pad, sometimes referred to as a blanket, is
tucked into the doors of the booth. There is usual-
ly only one large pad on each door. Oversized
SAR-1 media pads can be easily trimmed.
The SAR-1 media is a premium choice for cross-
draft requirements. The tackifier and heavily cal-
lendered exit side allow for excellent particle reten-
tion. The SAR-1 is a premium choice for crossdraft
filtration.
SAR-1 Panels for Air Intake
Model SAR1Pxx-xxxx
For use in crossdraft and some downdraft
booths.The SAR-1 PANEL, made in Switzerland, is
a premium choice for panel filtration. The SAR-1
PANEL is made from two media pads. A metal
support is dielectrically heat sealed in between the
two media layers providing support and rigidity.
The first media layer is designed to catch large par-
ticles entering the booth. The second media layer
is designed to catch the smaller particles. 100% of
the fibers in the second layer are tackified to retain
trapped particles. The combination of small fiber
size and a callendered exit provide unsurpassed
R-1 filtration.
The metal support is made from 9 gauge galva-
nized steel, which will not rust. The support is
formed into a rectangular shape and contains two
crossbars for added stability.
When choosing the correct size, measure the metal
support. The metal support will be 3/8” under the
listed size. For instance, a 20x20 panel’s ring will
measure 19-5/8 x 19-5/8. Crossdraft booths will
have a series of housings that look like square or
rectangular holes in the booth doors. Panel filters
have extra media overlapping the metal support
which act as gasketing when placing the panel filter
inside the housing and create a tight seal to prevent
any air bypass around the filter.
Flanders - Foremost in Air Filtration
Corporate Headquarters, St. Petersburg, FL
the filter and hvac store