Honeywell 11255 - Manual (Page 20)

20
Flanders - Foremost in Air Filtration
Corporate Headquarters, St. Petersburg, FL
325T, which is 98% efficient, and the Series 425T
which is 99% efficient. The exhaust cube filters
have a larger surface area than a conventional flat
pad. This increase in surface area reduces the
restriction to airflow, and increases the paint hold-
ing capacity of the filter. This means better airflow
and longer life.
The Series 325T is made from a polyester media
supported by a 9 gauge wire frame. The dual
denier media is used as an initial barrier, and a
tightly woven thin media is used as a final particle
barrier. This filter captures an average of 98% of
overspray in weight.
The Series 425T has an added layer of media
applied to the downstream side of the filter.
Although the construction is the same as the Series
325T, the added layer of single denier polyester
fibers gives the Series 425T a 99% efficiency rat-
ing.
PS125-Bag
Models 125BAG-xxxxxx
Scrim-Back Polyester Media Bags for use as a sec-
ondary paint arrestor in selected booths.
Each bag is hand sewn and attached to a 9 gauge
galvanized support frame, and includes a 1” head-
er for easy placement in side access housings.
Special bags may require a wire support basket, no
header or frame, or loops at the end of each pock-
et for support.
The media is a 1” single denier polyester fiber with
a scrim backing. This media has little effect on the
airflow, and has a high dust holding capacity. The
unique pocket design increases the surface area of
the media. This increase in surface area will
increase the life of the filter, and reduce the pres-
sure drop.
If the exhaust bag is the same size as a booth’s
intake bags, it is common to rotate the intake bags
to the exhaust bags to reduce costs. Bag meas-
urements are nominal in size. If a bag is 15.5” x
24.5” x 19.5”, the listed size is 16” x 25” x 20”.
Please note this difference when measuring your
exhaust bags.
Andrea and PS125 Exhaust Filters
Models ANDREA and 125PAD-xxxx
The Andrea filter is a paper paint arrestor with a
unique design. Kraft paper is pleated into an accor-
dion-like form with holes punched in the paper at
consistent intervals. A second layer of paper is
attached to the back with different hole placements.
When air passes through the filter, it hits the wall of
the second kraft paper layer and is diverted through
the second hole. This air turbulence and laws of
motion cause the paint to collect on the paper and
cleaned air to pass through the filter.
The PS125 Water Wash Pads are designed specif-
ically for use in select Spraybake brand booths.
Certain models of Spraybake use a water wash
system as a secondary exhaust. This water wash
system requires special pads to be used to filter out
particulate in the system. The fiber has a reinforced
scrim backing on the downstream side to prevent
fiber breakoff or migration. The water wash pads
are also available in custom sizes.
*Our filters are not affiliated with SPRAYBAKE®. Use of the
registered SPRAYBAKE® name is for comparative purposes
only.
Series 225-Panel
Models 225RT-xxxx and 225LT-xxxxx-xx
2-ply Panel and Link Filter for use as a prefilter in
downdraft booths. The 2 ply panel filters are con-
structed using two layers of poly-synthetic fibers.
These layers are designed to capture large parti-
cles in the first layer and smaller particles through-
out the second layer.
A 9 gauge wire frame with two cross pieces is
dielectrically heat sealed inside the filter for sup
the filter and hvac store