Honeywell DCP552 Mark II - Manual (Page 32)

4 - 3 Making Terminal Connections
4-4
To connect a line to the terminals, use crimp-style solderless wire connectors that fit an M3.5 screw.
Handling Precautions
•If the DCP552 is mounted in a location subject to noticeable vibration or
impact, be sure to use round crimp-style solderless wire connectors to
prevent lines from becoming disconnected from the terminals.
•Be careful not to allow any of the crimp-style solderless wire connectors to
touch adjacent terminals or connectors.
•The terminal screws shall be tightened to 0.78 to 0.98 N
•
m torque.
7.4
6.6 or less
¿3.7
7.3 or less
Unit : mm
Chapter 4. WIRING