Heatiator Heatilator GB4336 - Manual (Page 28)

28 Heatilator • GB4336/GB4992 • 4003-085 Rev H • 04/06
A. Before Lighting Appliance
Before lighting this appliance, determine if it has a stand-
ing pilot or Intellifi re ignition system by opening the control
access panel to view wiring system and gas valve. If this
appliance has a red or black ignitor button (See Figure 10.1)
this appliance has a standing pilot ignition system. If there is
no red or black ignitor button, this appliance has an Intellifi re
ignition system.
If installing Intellifi re Ignition battery backup:
• Do not install batteries if the backup mode may
not be used for extended time.
• Batteries may leak.
• Install batteries only when needed for power
outage.
CAUTION
Fire Risk
Burn Risk
HOT! DO NOT TOUCH.
SEVERE BURNS MAY RESULT.
CLOTHING IGNITION MAY RESULT
Glass and other surfaces are hot during
operation and cool down.
WARNING
• Keep children away.
• CAREFULLY SUPERVISE children in same room as
appliance.
• Alert children and adults to hazards of high
temperatures.
• Do NOT operate with protective barriers open or
removed.
• Keep clothing, furniture, draperies and other
combustibles away.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. Refer
to the owner’s information manual provided with this
appliance. For assistance or additional information consult
a qualifi ed installer, service agency or the gas supplier.
WARNING
Do NOT use this appliance if any part has been under
water. Immediately call a qualifi ed service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
WARNING
Before operating this appliance, have a qualifi ed
technician:
• Remove all shipping materials from inside and/or
underneath the fi rebox.
• Review proper placement of logs, rockwool, lava rock and
vermiculite.
• Check the wiring.
• Check the air shutter adjustment.
• Ensure that there are no gas leaks.
• Ensure that the glass doors are in the proper position.
• Ensure that the fl ow of combustion and ventilation air is
not obstructed (front grilles and vent caps).
13 13
Operating Instructions