Fusion F300S - Manual (Page 98)

98 F300S/F300SQ Ultraviolet Lamp System
Figure 36. Reflector Screw Tightening Sequence (I310M/I311M)
8. When the reflector is properly installed, the face should be flush and even with
the outer face of the two end reflectors as shown in Figure 35 .
9. Clean the reflector to remove fingerprints.
10. Clean and insert the lamp bulb as instructed earlier in this chapter.
11. Replace the screen assembly. Hand-tighten the four M3 screws in sequence as
shown in Figure 37 until snug. Tighten the fasteners in sequence to 0.9 N-m (8
inch-lbs) using a torque-controlled screwdriver. Repeat tightening the fasteners
according to the sequence and torque specified.
NOTE: After installing the reflector in the irradiator, the reflector mounting
screws should be retightened (using a torque-controlled screwdriver to 3.4 N-m
(30 inch-lbs) after a minimum of 10 minutes of operation.
Figure 37. RF Screen Screw Tightening Sequence (I310M/I311M)