M-S Cash Drawer A794 - Manual (Page 130)

A794 Owner’s Guide Chapter 6: Programming Information
December 1999 125
Print Data in Page Mode
ASCII ESC FF
Hexadecimal 1B 0C
Decimal 27 12
Collectively prints all buffered data in the printing area.
After printing, the printer does not clear the buffered data and sets values for Select
Print Direction in Page Mode (1B 54 n) and Set Print Area in Page Mode (1B 57 …), and
sets the position for buffering character data.
Exceptions
This command is enabled only in Page Mode.
Select Page Mode
ASCII ESC L
Hexadecimal 1B 4C
Decimal 27 76
Switches from Standard Mode to Page Mode. After printing has been completed either
by the Print and Return to Standard Mode (FF) command or Select Standard Mode (1B
53) the printer returns to Standard Mode. The developed data is deleted after being
printed. For more information see Page Mode in this document
This command sets the position where data is buffered to the position specified by
Select Print Direction in Page Mode (1B 54) within the printing area defined by Set Print
Area in Page Mode (1B 57).
This command switches the settings for the following commands (which values can be
set independently in Standard Mode and Page Mode) to those for Page Mode.
♦
Set Right-Side Character Spacing (1B 20)
♦
Select 1/6-Inch Line Spacing (1B 32)
♦
Set Line Spacing (1B 33)
It is possible only to set values for the following commands in Page Mode. These
commands are not executed.
♦
Select or Cancel 90 Degree Clockwise Rotation (1B 56)
♦
Set Counter Clockwise Rotation (1B 12)
♦
Select Justification (1B 61)
♦
Select or Cancel Upside-Down Printing (1B 7B)
♦
Set Left Margin (1D 4C)
♦
Set Print Area Width (1D 57)
Exceptions
The command is enabled only when input at the beginning of a line
The command has no effect if Page Mode has previously been selected.