M-S Cash Drawer A794 - Manual (Page 138)

A794 Owner’s Guide Chapter 6: Programming Information
December 1999 133
Select Memory Type (SRAM/Flash) Where to Save Logos or User-Defined Fonts
ASCII GS " n
Hexadecimal 1D 22 n
Decimal 29 34 n
Value of n: 48 - 51
n = 48 (ASCII n = 0)
Loads active logo to RAM only. This is used to print a special logo but not have it take
up Flash Memory. A logo defined following this command is not preserved over a
power cycle.
n = 49 (ASCII n = 1)
Loads active logo to Flash Memory. This is the default condition for logo Flash storage.
A logo defined following this command is stored in Flash Memory.
n = 50 (ASCII n = 2)
Loads user-defined characters to RAM only. This is the default condition for user-
defined character storage. Any user-defined characters defined following this command
are not preserved over a power cycle.
n = 51 (ASCII n = 3)
Loads user-defined characters to Flash Memory. An application must use this command
to store user-defined characters in Flash Memory. Any user-defined characters defined
following this command are stored in Flash Memory. A user-defined character cannot
be redefined in Flash Memory. The Flash Memory page must be erased by an
application before redefining user-defined characters. For more information, see the
Erase User Flash Sector (1D 40 n) command.
Specifies whether to load the logos or user-defined characters to Flash Memory or to
RAM (volatile memory). The selection remains in effect until it is changed via this
command or until the power cycles.
Related Information:
This command is recognized in A794 Native Mode. In A793 and TM-T88 Emulations,
parameter bytes go into the print buffer.