Cash drawer cables, Power supply cable – M-S Cash Drawer A794 User Manual
Page 15
Chapter 2: Using the Printer
A794 Owner’s Guide
December 1999
10
Cash Drawer Cables
The Cash Drawer Cable connects the printer to one or two cash drawers.
1.
Open Connector Cover at rear of printer if not previously open.
2.
Plug the cable into the Cash Drawer Connector (standard phone jack) located at the
rear of the printer (see illustration on previous page.)
Note:
a.
If your system has two cash drawers, attach a Y-cable to the printer’s Cash Drawer
Connector as shown.
b.
Leave some slack in the cord to route through the Strain Relief at a later time.
Printer
Y-Cable
Drawer
Drawer
Printer Connector
(Standard Phone Jack)
Power Supply Cable
Connect the Power Supply Cable last.
1.
Plug the Power Cord into the Power Supply.
2.
Plug the Power Cord into the Power Connector located at the rear of printer (see
illustration on previous page.)
3.
Snap the Connector Cover closed, ensuring that the Communication, Cash Drawer
and Power Supply Cables are aligned with the slots provided for each in the
Connector Cover. Verify that the strain relief on the Connector Cover aligns with
Power Supply Cable.
4.
Plug the Power Supply into a grounded outlet. The Green LED on the top cover will
light up.