M-S Cash Drawer A794 - Manual (Page 21)

Chapter 2: Using the Printer A794 Owner’s Guide
December 1999 16
Configuring the Printer
The Configuration Menu allows the user to set general printer parameters. The test
prints the settings for several functions, and partially cuts the paper between each
variation.
The printouts may vary for each model. The test ends with a partial cut of the paper,
then begins again. A test printout may use several feet of paper to complete.
Paper Feed
Button
Reset
Button
Off
Switch 1 is shown
in the ON position
On
DIP Switches
1 2
Back of Printer DIP Switches
Rear
Cover
To start the test:
1. Set DIP Switch 1 to ON position (down.) DIP Switch 2 must always be set to ON
position (down.)
2. Place paper into the bucket as described in the previous section, “Changing Paper.”
3. Press the Reset Button.
4. Press and hold the Paper Feed Button while closing the cover.
♦
The printer prints the Diagnostics Form and the Configuration Main Menu.
♦
Printer pauses and waits for Main Menu selection to be made (see sample
printout on the next page.)
5. Continue through your menu selections until you are asked to: “Save New
Parameters?”. Select Yes or No.
a. If answer Yes is selected, return DIP Switch 1 to OFF position (up.)
b. Repeat Steps 3 and 4 above.
♦
Diagnostic printout verifies new settings. (See sample printout on the
following page.)
6. If answer NO is selected, printer returns to the menu to set parameters again.