Connect the cables, Communication cable – M-S Cash Drawer A794 User Manual
Page 14
A794 Owner’s Guide
Chapter 2: Using the Printer
December 1999
9
Connect the Cables
Caution:
Connect the cables to the printer before plugging in the power supply. If
power is received from the host computer, turn it off before connecting any cables.
Back of
Printer
Communication
Connector
(RS-232C 9-pin DB-9
Connector shown)
Power
Connector
6-pin Cash Drawer
Connector
Connector
Cover
Note:
Depending on your printer configuration, the connector panel may vary from the
above illustration.
Communication Cable
The communication cable connects the printer to the host computer. To install the
communication cable:
1.
Turn off the host computer.
2.
Open the Connector Cover at the rear of the printer.
3.
Attach the Communication Cable to the connector shown on the back of the printer
above. Tighten the screws to secure the cable.
4.
Connect the cable to the host computer.