Muratec F-150 - Manual (Page 14)

1.6
Getting started
Pick an installation spot before going ahead
Where should you install your fax machine? The location should be:
• Clean — Dust buildup can damage your machine. (However, do not use a cover!
See next item.)
• In the open — Allow at least 12 ″ of clearance around your machine. Be sure
that you never cover the machine: its vents must be able to “breathe.”
• Away from direct sunlight — This helps avoid overheating.
• Dry — Avoid any location where splatters or sprays (such as from a water foun-
tain) could reach your fax machine.
• Level, and vibration-free.
• Near a phone jack — Your fax machine uses a standard (“modular”) telephone
jack, also known as an RJ-11.
• Near an AC power outlet — The AC power cord is about 5 ′ long when stretched
to its limit (and that’s not the way to handle a power cord).
Speaking of which …
Please heed these power-ful tips
• Use a standard three-pronged 120 VAC outlet.
• Make sure the outlet isn’t controlled by a wall switch.
If it is, you’ll risk inadvertent shutoffs of your machine, causing
you to lose fax messages.
• Don’t use an outlet which also is supplying power to a
large appliance, such a refrigerator or air conditioner.
Such high-consumption appliances can cause “draw-downs”
(temporary drops in the power available for other equipment on
the circuit) which could damage your fax machine.
• If at all possible, use an electrical surge suppressor, preferably one which
guards both telephone and electrical lines. This device helps to shield your fax
machine from damaging high-voltage electrical surges.
Voltage requirements: 120 VAC ± 10%, 50–60% Hz.
Power consumption: Standby Transmission Reception Copying Maximum*
F-150 15 W 41 W 379 W 374 W 396 W
F-120/F-100 14 W 37 W 373 W 372 W 396 W
* F-150 and F-120; simultaneous copying, communicating and scanning.
Install the printing supplies
Your fax machine prints incoming faxes and copies with a laser print engine. The
engine requires two types of printing supplies (sometimes also called consumables):
• The drum cartridge — It yields 20,000 normal letter-sized printouts (see “Specifi-
cations,” page AI .1). By “normal,” we’re referring to the amount of text and/or
graphics on each page. This is based on an industry-standard test document.
• The toner cartridge — It yields 5,500 such printouts (see “Specifications,” page AI .1).
Note: The toner cartridge included with your machine is a starter cartridge which
yields 3,600 printouts (see “Specifications,” page AI .1). Please purchase
regular, full-yield toner cartridges from your authorized Muratec dealer.
Here’s how to install these supplies.
1 Swing open the printer
cover by pressing the
printer cover release.
2 Unpack the drum cartridge from its box.
Important: Shield the drum cartridge from light, especially strong
light. Later, if you have to remove the cartridge from the fax,
immediately wrap it in a thick cloth to protect it from light.
3 Put the drum cartridge into the printer
by aligning the cartridge’s protrusions
with the slits inside the printer frame.
Important: You must also reset the
drum counter. See “When
you install a new drum
cartridge …” (page 1.7).
Setting up