Muratec F-150 - Manual (Page 85)

Beyond the basics
To clear another department code, repeat steps 2–3.
To finish clearing department codes, press
STOP to return to standby mode.
Activating (or turning off) the department code setting
1 Press / PROGRAM , M , 3, ENTER . The LCD shows:
Note: If department code operation is protected (see next item), the fax will
beep briefly and then return to standby mode. You will have to turn
off the protection first, then repeat this step.
2 Press or / PROGRAM once or twice until you see the setting you want.
3 Press ENTER .
Activating (or turning off) department code protection
Important: This feature will work only if you’ve set the passcode (see page 2.44).
1 Press / PROGRAM , M , 1, ENTER . The LCD shows:
2 Use the numeric keypad to enter the four-digit passcode:
To change only one digit, repeatedly press to move leftward or / PROGRAM
to move rightward until the cursor is under the digit, then use the numeric
keypad to enter the correct digit.
3 Press ENTER .
Dept. Protect: Off
Program/Enter
Set. Dept. Protect
Dept. On/Off: On
Program/Enter
Dept. On/Off: Off
Program/Enter
2 Press / PROGRAM repeatedly until you see the code you wish to clear.
3 Press CANCEL .
2.56