Muratec F-150 - Manual (Page 34)

2.5
Beyond the basics
1 Press / PROGRAM , J , 0, 3, ENTER . The LCD shows the current copy reduction rate:
If the setting you see is acceptable, skip to step 3.
Otherwise, proceed to step 2.
2 To change the setting, press or / PROGRAM repeatedly until your chosen
reduction setting appears. In this example, we’ve chosen 75%.
3 Press ENTER to save the setting. The LCD shows the current setting for the
reduction margin:
If the setting you see is acceptable, skip to step 5.
Otherwise, proceed to step 4.
4 To change the setting, use the numeric keypad to enter the reduction margin
you want. If necessary, press
or / PROGRAM to move the cursor if you
need. In this example, we’ve chosen 00mm.
5 Press ENTER to save the setting.
Setting the number of rings
You can set how many times your fax machine will ring before answering a call.
You may choose one to nine rings.
1 Press / PROGRAM , J , 0, 6, ENTER . The LCD will show:
If the setting you see is acceptable, skip to step 3.
Otherwise, proceed to step 2.
2 To change the setting, use the numeric keypad to enter the desired number of
rings, from one to nine. Here, we’ve chosen four rings.
Note: If you enter 0 (zero), the machine will beep brie¾y to warn you that it
can’t accept that setting.
3 Press ENTER to save the setting.
Setting ECM
Ever hear static on the line during a phone call? It’s a real nuisance — but, worse, it
may ruin your attempts to communicate via fax. This is because “line noise” can
easily disrupt the flow of data from one fax machine to another.
That’s why your fax machine gives you the chance of operating in Error Correction
Mode (
ECM ). When two fax machines communicate while running in ECM , the send-
ing machine automatically checks the data, “block” by “block,” as it sends. If the
receiving fax machine can’t verify the transmission, the first machine will re-send
as necessary. (Essentially, the sending machine asks, “Did you ‘hear’ that seg-
ment?” and the other machine answers either “Yeah; go on” or “No; try it again.”)
Note: While using ECM gives you a better chance of getting a fax document
through a troublesome phone line, it also could slow down the transmission
time — and increasingly so in proportion to how bad the phone line is.
That’s why we let you turn
ECM on or off as you require.
Note: Not all fax machines have ECM . If you’ve activated ECM and then transmit to
a fax machine not currently using ECM , there will no change in the fax
transmission from a usual, non- ECM transmission.
1 Press / PROGRAM , J , 0, 8, ENTER . The LCD shows the current ECM setting:
If the setting you see is acceptable, skip to step 3.
Otherwise, proceed to step 2.
2 To change the setting, press or / PROGRAM once or twice until your chosen
setting appears. In this example, we’ve chosen Off.
3 Press ENTER to save the setting.
ECM Mode: Off
Program/Enter
ECM Mode: On
Program/Enter
Set # Of Rings
Set # Of Rings
Copy Reduc Rate:
75%
Copy Reduc Rate:
75%
Copy Reduc Rate:
75%
Copy Reduc
Rate:Auto