Muratec F-150 User Manual
Page 80
Beyond the basics
5
To change the setting, press
or /
PROGRAM
repeatedly until your desired
setting appears. In this example, we’ve chosen “Mode1.”
6
Press
ENTER
.
Autodialing while using the
PIN
mask
Note: The following instructions presume you are familiar with how to set and use
your machine’s autodialer. If you need to review, see pages 2.8–2.16.
Note: If the
PIN
mask feature is off, you use the autodialer normally.
If you’ve specified “Mode 1” — the
PIN
goes in
In this mode, before autodialing the desired number the first time, you must add
the
PIN
to its stored one-touch key or speed-dial number. Here’s how:
1
Make a normal autodialer entry through the entry of the call group(s).
The
LCD
will show:
2
Use the numeric keypad to enter the four-digit passcode. Here, we’ll use our
sample passcode again.
3
Press
ENTER
. In our example, we’re setting speed-dial number 001:
4
Use the numeric keypad (including either * or #, if necessary) to enter the
desired
PIN
, up to eight characters in length.
5
Press
ENTER
to save the
PIN
.
Note: If you press
ENTER
without entering the
PIN
, the fax machine beeps,
indicates “Invalid Number” on the
LCD
and then returns you to step 3.
Now you may autodial the number as usual.
Important: While in
PIN
Mode 1, any autodialer numbers you use must include
the
PIN
. Thus, this applies also to autodialer numbers used with batch
transmission (see pages 2.24–2.27) or programmable one-touch keys
(see pages 2.36–2.43).
Note: If you select either Mode 1 or Mode 2 and will be using batch transmission
(see pages 2.24–2.27), you must store the
PIN
access code for the remote unit
within the appropriate batch box.
If you’ve specified “Mode 2” — as you autodial, load the code
In this mode, you don’t have to add the
PIN
to the autodialer setting itself. Instead,
you enter the
PIN
manually each time you autodial:
1
Perform the usual autodialing procedure for the number itself. Here, we’ve
pushed one-touch key
A
:
2
Press
START
. The machine now asks for the
PIN
:
3
Use the numeric keypad to enter the
PIN
.
4
Press
START
. Your machine will dial the number.
Note: If you select either Mode 1 or Mode 2 and will be using batch transmission
(see pages 2.24–2.27), you must store the
PIN
access code for the remote unit
within the appropriate batch box.
Enter PIN Number
1057_
Enter PIN Number
_
Press Start
A_
001:PIN Number
1057_
001:PIN Number
_
Set PIN Number
Set PIN Number
PIN Mode:
Mode1
2.51