Muratec F-150 - Manual (Page 69)

Beyond the basics
Programming a relay broadcast initiation
Note: To erase a programmable one-touch key, refer to page 2.43.
Note: For this operation to work, three things must be true:
• The remote fax machine must be a Muratec fax machine (other than an
F-86) with “hub” capability.
• The call group(s) to which you’re faxing must exist on the remote machine.
• You must know the two-digit number for each call group to which you’re
faxing.
To program a relay broadcast initiation into a programmable one-touch key:
1 Press / PROGRAM , C , 1, ENTER . The LCD either shows:
… or indicates a command already is programmed into this key.
If P 01 is the key you want to program, skip to step 3. (However, our examples
from here will say “ P 05” rather than “ P 01.”)
2 Select the key in which you want to program a command or change a previ-
ously stored command — if necessary, turn the fliptab to see it, as described
earlier — and then press it. Here, we’ve selected
P 05.
3 If you change your mind and wish to select a different programmable one-
touch key, go back to step 2 before going on to step 4.
4 Press ENTER . The LCD now shows either
or
5 Use the numeric keypad to enter the “hub” machine’s number exactly as your
machine should dial it, including whatever codes your phone system may
require. The number can be up to 40 characters in length:
Your display can show only 20 characters at a time. To view characters beyond
those 20 (such as with an international long-distance number), press
to
scroll leftward or / PROGRAM to scroll rightward.
Important: Do not press ENTER .
Note: If you make a mistake or want to erase characters entered in a previ-
ous setting, press CANCEL to erase leftward. Or, if you want to change
just one character in the number, press to move the cursor leftward,
or / PROGRAM to move it rightward, to that character. Then re-enter
until the number is just as you want it.
6 Now, while you still can see the fax number on the LCD , press
COMMUNICATION OPTIONS three times and then press ENTER . The LCD shows:
7 Use the numeric keypad to enter the two-digit identifier (01–32) for the first
call group. You can specify up to 10 separate groups for each relay broadcast
initiation; between the entry of each new group, press
GROUP DIAL to insert a
comma but do not insert a comma after the last group number.
For example, here, we’ve entered 0, 4,
GROUP DIAL , 1, 1, GROUP DIAL , 2, 4:
Note: The LCD shows only four characters of the group numbers.
Important: Again, do not insert a comma after the last group number.
When finished, press ENTER .
8 If you want the transmission to begin immediately every time you press the
key, press
ENTER and skip to step 11.
If you want to delay the transmission (perhaps to take advantage of lower
phone rates), press
COMMUNICATION OPTIONS , ENTER .
Relay Tx
Relay Tx
Group No. _
P05:Fax Number
9-5550629
P05:Fax Number
9-5558743 P05:Fax Number
_
Select Program No.
Select Program No.
2.40