Muratec F-150 - Manual (Page 24)

1.16
Getting started
Sending a fax with on-hook dialing or a handset
You also can fax a document by dialing using either the monitor speaker (This is
called “on-hook” dialing) or the optional handset.
Notes: On an F-150, faxing this way disables “V.34” mode and sends the fax in nor-
mal ITU - T Group 3 fashion.
1 Insert the document.
2 Adjust resolution and contrast if necessary. If these are OK , skip to step 3.
Otherwise, press RESOLUTION to change the resolution and/or press CONTRAST
to change the contrast.
3 Obtain a dial tone. You can do this by either:
• Activating the monitor speaker (by pressing
MONITOR / CALL )
… or …
• Lifting an optional handset.
In either case, the LCD shows:
4 Enter the fax number by using the numeric keypad.
Note: For information on entering one-touch and speed-dial numbers, see
pages 2.8–2.16.
Enter access codes along with the number, just as for a regular phone call.
5 When you hear fax tones from the remote unit, press START .
Note: If a person answers the phone, tell him or her you’re trying to send a
fax. When his/her machine sends you fax tones, then press START .
6 If you’re using the monitor speaker, skip to step 7.
If you’re using an optional handset, hang up (after pressing
START ).
Note: What if the call fails for some reason? See “If the call doesn’t go
through: redialing,” next column.
7 At the end of the operation, your fax machine beeps and displays:
If the call doesn’t go through: redialing
If the call fails (and you were using neither the monitor speaker or an optional handset),
your machine will redial, automatically, the fax call you just tried. While in this Auto
Redial mode, the machine can receive faxes and make as many as 99 fax transmissions.
If you dialed without using either the monitor speaker or an optional handset, your
fax automatically redials the number every few minutes (you set the interval; see
“Making redial settings,” next page) until one of these happens first:
• It reaches the remote fax machine.
• It has automatically redialed the number for the last try (again, see “Making
redial settings,” next page).
Notes: If you used either the speaker or a handset, redial manually (see below).
If the last try fails, your machine may print (and/or display) error messages.
For more information, see pages 3.6–3.9.
Redialing manually
You always can redial fax or voice calls manually; and, again, you must redial man-
ually if you dialed by using either the monitor speaker or an optional handset.
To redial a fax call manually without using the monitor speaker or an optional hand-
set:
1 Confirm that the document is still in the feeder and that your desired resolu-
tion and contrast settings are still correct.
2 Press REDIAL / PAUSE , START .
To redial a fax call manually by using the monitor speaker or an optional handset:
1 Confirm that the document is still in the feeder and that your desired resolu-
tion and contrast settings are still correct.
2 Obtain a dial tone: either press MONITOR / CALL or lift the optional handset.
3 Press REDIAL / PAUSE .
4 When you hear fax tones from the remote unit, press START .
Note: If a person answers the phone, tell him or her you’re trying to send a
fax. When his/her machine sends you fax tones, then press START .
972-555-2009
** Complete **
** Tel Mode **
919725552009_
** Tel Mode **
_