Getting everything just the way you want it, Setting up for scans – Muratec F-150 User Manual
Page 31
Beyond the basics
The EasyStart feature guided you through the “just-gotta” settings on your machine.
In the next few pages, we’ll cover other settings.
Setting up for scans
You can set parameters regarding how your fax machine scans documents for either
faxing or copying:
• Primary transmission mode — Gives you four ways to send faxes, either one
of the three resolution modes — normal, fine or superfine (“S Fine” on the
LCD
)
— or in grayscale mode (“Gray”).
• Primary contrast mode — Sets how light or dark you want faxed documents
to be when they arrive at their destinations.
• Scanning width (F-150 only) — Set how wide an area your fax machine scans
per page.
1
Press /
PROGRAM
,
J
, 0, 1,
ENTER
. The
LCD
asks which resolution you select:
If the setting you see is acceptable, skip to step 3.
Otherwise, proceed to step 2.
2
To change the setting, press
or /
PROGRAM
repeatedly until your chosen
mode appears. In this example, we’ve chosen fine resolution.
3
Press
ENTER
to save the setting. The
LCD
asks which contrast setting you select:
If the setting you see is acceptable, skip to step 5.
Otherwise, proceed to step 4.
4
To change the setting, press
or /
PROGRAM
repeatedly until your chosen
setting appears. In this example, we’ve chosen light contrast.
If your machine is either an F-120 or F-100, skip to step 7.
If your machine is an F-150, proceed to step 5.
5
Press
ENTER
to save the setting. The
LCD
asks which scanning width you select:
For most uses, “
A
4” is the proper setting; it scans the central 8.2
″
of each
page. However, for documents of unusual width, you may wish to use the “
B
4”
setting, which scans the central 9.9
″
of each page. (See “
A
4,
B
4,
A
3” in the
Glossary beginning on page 3.17.)
If the setting you see is acceptable, skip to step 7.
Otherwise, proceed to step 6.
6
To change the setting, press
or /
PROGRAM
repeatedly until your chosen
setting appears. In this example, we’ve chosen “
B
4”.
7
Press
ENTER
to save the setting.
Of course, you always can change the resolution and contrast before sending. (You
can change the scanning width only through the previously described procedure.)
To adjust the resolution and contrast:
• Press
RESOLUTION
to change the resolution.
• Press
CONTRAST
to change the contrast.
Scan Width: B4
Program/Enter
Scan Width: A4
Program/Enter
Contrast: Light
Program/Enter
Contrast: Normal
Program/Enter
Primary: Fine
Program/Enter
Primary: Normal
Program/Enter
Getting everything just the way you want it
2.2