Intermec 6400 - Manual (Page 62)

Operation SECTION 2
2-20 6400 Hand-Held Computer User’s Guide
stop bit with an ASCII STX (hex 02) before the data and an
ASCII ETX (hex 03) after the data. No protocols, such as
ACK/NAK, RTS/CTS, or XON/XOFF, are supported. All
8-bit characters between the STX and ETX will be stuffed
in the PC BIOS key buffer.
Setting Terminal Emulation to
Accept Tethered Laser Scanners
1. In AUTOEXEC.BAT, ensure the scanner driver is
loaded with 64SCN7B --T1 --I0
2. From the Terminal Emulation mode, press the yellow
and then the blue keys to enter the Terminal Emula-
tion Main Menu.
3. Select option 1) Set-up Parms.
4. Enter password CR52401.
5. Select option 2) Barcode Parms.
6. At Scanner Type menu select 3) Laser and press
[ENT] five times.
7. At Main Menu select 4) Tests
8. At Tests menu select 1) Peripherals
9. At Peripherals menu select 5) Scanner Test
If you experience problems with using your laser scanner
with terminal emulation try these steps:
1. Reboot to the DOS prompt ([YELLOW] [BLUE]
[ENT] [ENT]) press 0 at pause.
2. Type DEL CONFIG.DAT press [ENT].
3. Press [CTRL] [ALT] [DEL] to reboot.