Intermec 6400 - Manual (Page 92)

Terminal Emulation Menu Screens SECTION 3
3-20 6400 Hand-Held Computer User’s Guide
When this option is OFF, and the scanned bar code is too
big for the input field, the overflow information is dropped.
Scan All Fields: When you select this option the scanner
is enabled whenever the cursor is in an input field. When
this option is OFF, the host computer must enable the scan-
ner for each input field that requires scanned data.
After you press the [ENT] key, the display advances to
additional Scan Options menus.
To enable the scan options, press the numeric key(s) corre-
sponding to the options you want, then press [ENT]. You
can enable more than one Scan Option at a time.
Scan PreChar and Scan PostChar: Enter a hexadeci-
mal value from 00--FF for the character to be sent preced-
ing the scanned data or after the scanned data. The value
of 20h means that pre or post characters are not sent.
1)
2) Scan PreChar
3) Scan PostChar
Scan Options
Scan Options To Enable Bar Codes
There are menus of options to enable (or disable) various
bar code symbologies. To enable a bar code, press the nu-
meric key corresponding to the number of the bar code
symbology (as shown on the menu), then press the [ENT]
key.
After enabling a particular bar code you may have to select
various options for the bar code. After selecting the desired
options, you are prompted to set length requirements (such
as minimum and maximum length, fixed lengths, leading
and trailing character options, etc.).
Once the length requirements have been set, the computer
returns to the same Scan Options menu. You may then