Janome MEMORY CRAFT 10001 - Manual (Page 124)

123
1
2
3
Attaching embroidery foot P
Raise the foot, then loosen the Thumbscrew
and remove the Foot Holder to the rear.
Attach Embroidery Foot P to the presser bar
from behind. Tighten the Thumbscrew securely
with the screwdriver.
1 Thumbscrew
2 Foot Holder
3 Embroidery Foot P
Thread Holder
To prevent the needle thread from becoming
tangled, place the thread end on the Thread
Holder.
Pass the needle thread through the Hole on
Embroidery Foot P and draw it up to the thread
holder.
Hang the thread, 2 – 4 cm (3/4˝ – 1 1/2˝), on
the thread holder from the front to back.
1 Thread Holder
2 Hole on Embroidery Foot P
1
2