Janome MEMORY CRAFT 10001 - Manual (Page 22)

21
Removing and Attaching the
Presser Foot
Press the Up/Down Needle Button to raise
the needle to its highest position and raise
the Presser Foot Lifter.
Press the Red Button on the back of the foot
holder. The Presser Foot will drop off.
Attaching the presser foot
Place the selected Presser Foot so that the
pin on the foot lies just under the Groove of
the Foot Holder.
Lower the Presser Foot Lifter to lock the foot
into place.
1 Red Button
2 Groove of the Foot Holder
Button Sewing Foot T
To attach:
Insert the Rear Pi on the foot into theGroove
of the Foot Holder.
Gently lower the presser foot lifter, holding
the foot with your fingers.
3 Rear Pin
4 Groove of the Foot Holder
1 2
3
4