Janome MEMORY CRAFT 10001 - Manual (Page 28)

27
Ordinary
Sewing
Embroidery
Register
Common
Set
Built-in
inch/mm mm inch
Reset All to Defalts Yes
Key Position Adjustment
Yes
Resume Mode
Yes
Off
On
Yes
Format
ATA PC Card
8 Inch / Millimeter
You can set your machine’s measuring unit to either
“inch” or “millimeter” depending upon your
preference. The default measuring unit setting is
“millimeter”.
Press or key to select the unit you preferred.
NOTE:
• Stitch length and width are displayed in millimeter
regardless the inch/mm setting.
9 Resume Mode
The Resume Mode allows you to return to either
Ordinary Sewing Mode or Embroidery Mode, which
was selected when you turned the machine off.
To activate the Resume Mode, press key to
checkthe box on.
10 Key Position Adjustment
If you think the touch panel keys are out of align-
ment, you can correct it in the Key Position Adjust-
ment window.
When you press the Key, window (A) will be
shown. With your finger, press the Black + Sign as it
appears in order. When you press the last black +
sign, the window (B) will be shown.
The window will close and go back to the original
screen with the new setting being registered.
Formatting the memory bank
If the internal memory or ATA PC card does not
function due to damage to the memory bank, you
need to re-enable it by formatting the memory.
11 Formatting the Built-in memory
To format the internal memory, press the key
next to Built-in memory.
12 Formatting the ATA card
To format the ATA PC card or Compact Flash, press
the key next to ATA PC card.
13 Reset All to Default
Pressing the key will reset all the parameters to
their original settings (the same settings as when you
purchased the machine).
8
9
10
11
12
13
(A)
(B)
inch mm
On
Off
Yes
PRESS MARK(+).
Key Position Adjustment
END
Key Position Adjustment
Yes
Yes
Yes