Janome MEMORY CRAFT 10001 - Manual (Page 173)

172
1
3
2
4
5
6
7
6
8
9
Replacing a Light Bulb
WARNING:
• Turn the power switch off and disconnect
the power supply plug from the outlet
before replacing the bulb.
• Be careful not to touch the bulb while
it is hot. Wait until the lamp has
cooled down before touching it.
The Memory Craft 10001 is equipped with
dual sewing lights. One is located behind the
Face Plate and the other is on the underside
of the sewing arm.
To replace the light bulb behind the Face
Plate:
Open the Face Plate.
Remove the rubber Lamp Socket from the
Lamp Holder.
Pull out the bulb from the socket.
Insert a new Light Bulb into the socket,
making sure to align the Pins with the holes
on the socket.
Snap the socket back into the holder and
close the Face Plate.
1 Face Plate
2 Lamp Socket
3 Lamp Holder
4 Light Bulb
5 Pins
To replace the light bulb on the
underside of the sewing arm:
Lay the machine on its back.
Remove the Clear Window with the screw-
driver as shown.
Remove the rubber Lamp Socket from the
window.
Pull out the Light Bulb from the socket.
Insert a new bulb into the socket, making
sure to align the Pins with the holes on the
socket.
Snap the socket back into the fork on the
window.
Insert the window back into the opening on
the machine.
6 Clear Window
7 Lamp Socket
8 Light Bulb
9 Pins
CARE OF YOUR MACHINE