Janome MEMORY CRAFT 10001 - Manual (Page 79)

78
Adjust
33 34 35
37 38 39 40 41
42 43 44
1/2
Auto
A Z
32 36
Cordin g
H
1
2
Cording
Use the Cording Foot H to sew over one strand
of cording to create a pretty swirled design on
a jacket or vest. Sew over three strands of
cording for border trims.
Pearl cotton, knitting yarn, embroidery floss,
lace thread, fine wool or lily yarn can be used
for cording.
Select Pattern 33, for sewing three strands of
cording.
Mark the design on the right side of the fabric.
Draw the sewing threads to the left and under
the foot. Insert three strands of cording under
the Spring of the foot and draw them under the
foot to the rear.
1 Spring
Pull 10 cm (4˝) of cording behind the foot. The
Slots and bottom grooves on foot will hold
the lengths of cording in place while the
stitches form over the cording.
2 Slot
Hold the three strands parallel for even sewing
and be sure to match the stitches over the
strands. Stitch slowly and smoothly turning the
fabric as you sew while guiding the cordings
over the marked line.
NOTE:
• Select Pattern 34 and adjust the zigzag
width at 3.0, for sewing a single strand of
cording.
Use the center groove on the foot when
sewing a single strand.