Janome MEMORY CRAFT 10001 - Manual (Page 126)

125
Ordinary
Sewing
Embroidery
Register
Common
Set
On
Off
On
Off
Auto Tension
Center Line
Auto
2
Remaining Bobbin Thread
Grid Line
Grid Size
10 mm
1
2
3
4
Embroidery Mode Settings
To adjust a setting within Embroidery Setting
Mode, press the Embroidery Mode Setting key.
1 Auto Tension
The Auto Thread Tension level should be
adjusted when using other threads than the
Janome Embroidery thread. The tension level
can be adjusted within the range of -5 to +5.
Press the key to set the tension level
higher.
Press the key to set the tension level lower.
NOTE:
• The default setting “0” is an optimized level
for the Janome Embroidery thread.
2 Remaining Bobbin Thread
The machine will show a warning message if
the total amount of bobbin thread is not
sufficient.
You can change the level of the remaining
bobbin thread amount.
The default setting is at “2” and you can adjust
it in 5 steps from 0 to 4.
Press the key to set to a higher level.
Press the key to set to a lower level.
3 Grid Line
You can show or hide the Grid Lines in the
Embroidery Mode Setting window.
To show the Grid Lines, press key to check
the Grid Line box “On”.
4 Grid Size
You can change the grid size by choosing one
of the following three settings: 5 mm (3/16˝), 10
mm (3/8˝) and 15 mm (5/8˝).
The default setting is 10 mm.
Press the key to reduce the grid size.
Press the key to increase the grid size.
5 Centerlines
You can show or hide the Centerlines in the
Embroidery Mode window.
To show the Centerline, press the key to
check the Centerline box “On”.
6 Page Keys
Press key to view the next page.
Press key to view the previous page.
7 Register key
Press this key to register the new settings and
the screen will return to the previous mode.
8 Return key
Pressing this key cancels the changes that you
have made and returns the screen to the
previous mode.
5
6
7 8