Janome MEMORY CRAFT 10001 - Manual (Page 94)

93
1
2
4
3
5 6
7
Threading the machine for twin needle
Insert an additional spool pin, and put felt and
a spool on it.
Draw both threads from the spools and pass
them through the points from 1 to 6
Make sure that the two strings of thread from
the spools will not get tangled.
NOTES:
• Make sure each of the threads wind off
from the spools as shown.
• Threading from 1 to 6 is the same as for
single needle.
Slide one of the threads through the needle bar
thread guide on the left, and the other one on
the right.
Thread the needles from the front to back.
NOTES:
• The Automatic Needle Threader cannot be
used for the twin needle.
• When changing the sewing direction, raise
the needle and turn of the fabric.