SnapGear 2.0.1 - Manual (Page 29)

Getting Started
25
Next, you must modify your PC’s network settings to enable it to communicate with the
CyberGuard SG appliance.
Click Start -> Settings -> Control Panel and double click Network Connections.
Right click on Local Area Connection (or appropriate network connection for the newly
installed PCI appliance) and select Properties.
Select Internet Protocol (TCP/IP) and click Properties.
Figure 2-7
Select Use the following IP address and enter the following details:
IP address: 192.168.0.100
Subnet mask: 255.255.255.0
Default gateway: 192.168.0.1
Select Use the following DNS server addresses and enter:
Preferred DNS server: 192.168.0.1