SnapGear 2.0.1 - Manual (Page 69)

DHCP Server
65
Subnet List
The Subnet List will display the status of the DHCP server.
Interface
Once a subnet has been configured, the port which the IP addresses will be issued from
will be shown in the Interface field.
Subnet
The value shown in this field is the subnet for which the IP addresses distributed will use.
Free Addresses
This field will contain the number of remaining available IP addresses that can be
distributed. You may need to increase the number of IP addresses to hand out if this
value is 0.
Enable/Disable
Each subnet can be enabled or disabled by clicking on the Enable or Disable button
under the Enable/Disable heading.
Edit
The settings for each subnet can be modified by clicking the Edit button. You will also
have the option to add more IP addresses that can be handed out and add reserved IP
addresses as well.
Address Table
A table listing the status of each IP address that the DHCP server services for the subnet
can be viewed by clicking the Address Table button.
Delete
The settings for the subnet can be removed by clicking the Delete button.
Clicking the Address Table button will display a page similar to the following.