SnapGear 2.0.1 User Manual
Page 42
Network Connections
38
Figure 3-4
To manually configure your Internet network settings, enter the IP Address, Netmask,
Internet Gateway and DNS Server(s) supplied by your ISP. If you have been given a
range of IP addresses, they may be added as Interface Aliases. For details, see the
Advanced section later in this chapter.
Reboot your CyberGuard SG appliance to establish your Internet connection.
Bridged Internet
Select this enable bridging on the Internet port. For the CyberGuard SG appliance to
bridge between ports, you will have to select either Bridged LAN or Bridged DMZ as is
appropriate.
When bridging has been enabled, a Bridge / br0 port will appear in the Connections
menu. You may configure this interface with an IP address. This IP address will be used
primarily for accessing the CyberGuard SG appliance management console, and does
not necessarily have to be part of the networks that the CyberGuard SG appliance is
being used to bridge between.