Sony MHC-S90D - Manual (Page 42)

MHC-S90D 4-235-983-43(2) GB
42 GB
Presetting radio stations
You can preset 20 stations for FM and
10 stations for AM.
1
Press TUNER/BAND repeatedly to
select FM or AM.
2
Press and hold TUNING + or – until
“AUTO” appears in the display.
Scanning stops when the system tunes in a
station. “TUNED” and “STEREO” (for a
stereo program) appear.
3
Press TUNER MEMORY.
A preset number appears in the display. The
stations are stored from preset number 1.
4
Press ENTER (Tuner or remote).
The station is stored.
5
Repeat steps 1 to 4 to store other
stations.
To tune in a station with a weak
signal
Press TUNING + or – repeatedly to tune in the
station manually.
To set another station to an existing
preset number
Start over from step 1. After step 3, press
PRESET + or – repeatedly to select the preset
number where you want to store a new station,
then proceed to step 4.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
MHz
To change the AM tuning interval
(Except for European and Saudi
Arabian models)
The AM tuning interval is factory set to 9 kHz
(10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first,
then turn off the power. While holding down
ENTER (Tuner), turn the power back on.
Release ?/1 first, then release ENTER
(Tuner). Press ?/1 again. The AM tuning
interval is changed. When you change the
interval, AM preset stations will be erased. To
reset the interval, repeat the same procedure.
Listening to the radio
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations”).
1
Press TUNER/BAND repeatedly to
select the band you want.
2
Press PRESET + or – repeatedly to tune
in the preset station you want.
To Do this
Turn off the radio Press ?/1.
To listen to non-preset radio stations
In step 2, press TUNING + or – repeatedly
(Manual Tuning) or press and hold TUNING +
or – (Automatic Tuning).
Notes
• When the TUNER function is selected, the OSD
does not appear on the screen.
• When DVD is selected as the current function and
TUNER/BAND is pressed to select the TUNER
function, some time may be necessary before the
function can be switched.
• When you change the function from DVD to
TUNER, “WAIT” may flash on the front panel
display. While this flashes, there is no audio output.
Tuner
Preset number
MHz
Preset number Frequency