Siemens Gigaset S450 IP - Manual (Page 44)

43
SMS (text messages)
Gigaset S450 IP LBA / SGP / A31008-M1713-Y221-1-7619 / sms_BRD_neutral.fm / 30.8.07
Ve
rs
ion 4,
16
.09.
2005
SMS on a PABX
u You can only receive an SMS when the
Calling Line Identification is for-
warded to the extension of the PABX
(CLIP). The CLIP of the phone number
for the SMS centre is evaluated in your
Gigaset.
u If required, you must prefix the number
for the SMS centre with the access code
(depending on your PABX).
If in doubt, test your PABX, e.g. by
sending an SMS to your own number:
once with and once without the access
code.
u When you send SMS messages, your
sender number may be sent without
your extension number. In this case the
recipient cannot reply to you directly.
Sending and receiving SMS on ISDN
PABXs is only possible via the MSN
number assigned to your base station.
Activating/deactivating
SMS function
If you deactivate the SMS function, you
cannot send or receive SMS messages
with your phone.
The settings which you have made for
sending and receiving SMS messages (e.g.
the call numbers of the SMS centres) and
the entries in the incoming and draft mes-
sage lists are saved even after you switch
off your phone.
v Open
menu.
5 5 O 2 L
Enter the digits.
Q
§OK§ Deactivate SMS function.
Or:
1
§OK§ Activate SMS function (default
settings).
SMS troubleshooting
Error codes when sending
Self-help with errors
The following table lists error situations
and possible causes and provides notes on
troubleshooting.
E0 Calling Line Identification permanently
withheld (CLIR) or Calling Line
Identification not activated.
FE Error occurred during SMS transfer.
FD Connection to SMS centre failed, see self-
help.