Siemens Gigaset S450 IP - Manual (Page 60)

59
Using several handsets
Gigaset S450 IP LBA / SGP / A31008-M1713-Y221-1-7619 / T-NetBox_SAG-registration.fm / 30.8.07
Ve
rs
ion 4,
16
.09.
2005
Ending a consultation call
§End§ Press the display key.
You are reconnected with the external
subscriber.
Initiating a conference call
§Conf.§ Press the display key.
You are in a three-way conference call
with the external and the internal sub-
scriber.
If the internal subscriber who has been
called ends the call (press end call key
a), you will be connected with the
external subscriber. If you press end call
key a, the external call will be trans-
ferred to the internal subscriber.
Accepting/rejecting call waiting during
an internal call
If you get an external call while conduct-
ing an internal call, you will hear the call
waiting tone (short tone). With Calling
Line Identification, the caller's number or
name will appear in the display.
Ending an internal call, accepting an
external call
§Accept§ Press the display key.
The internal call is ended. You are con-
nected to the external caller.
Rejecting the external call
Precondition: the external call is waiting
on the fixed network connection.
§Reject§ Press the display key.
The call waiting tone is turned off. You
remain connected with the internal sub-
scriber. The ringer tone can still be heard
on other registered handsets.
Using a handset as a
room monitor
If the room monitor is activated, a previ-
ously stored destination number is called
as soon as a set noise level is reached in
the room.
You can store an internal or external
number in your handset as the destination
number.
The room monitor call to an external
number stops after around 90 seconds.
The room monitor call to an internal
number (handset) stops after around
3 minutes (depending on the base
station). During use as a room monitor,
all keys are barred except for the end call
key a. The speaker of the handset is
muted. The end call key can only be used
to deactivate the handset.
When the room monitor is activated,
incoming calls to the handset are indi-
cated without a ringer tone and are only
shown on the screen. The display and
keypad are not illuminated and advisory
tones are also turned off.
If you accept an incoming call, the room
monitor mode is suspended for the dura-
tion of the call, but the function remains
activated.
If you switch off the handset, the room
monitor mode is deactivated. You must
reactivate the function when you switch
the handset back on.
Please note:
You can not reject calls on the VoIP connection.