Siemens Gigaset S450 IP - Manual (Page 82)

81
Web configurator
Gigaset S450 IP LBA / SGP / A31008-M1713-Y221-1-7619 / web_server.fm / 30.8.07
Ve
rs
ion 4,
16
.09.
2005
STUN server
Enter the (fully-qualified) DNS name or
the IP address of the STUN server on
the Internet.
If you selected the option
Yes in the
STUN enabled field, you must enter a
STUN server here.
STUN port
Enter the number of the communica-
tion port on the STUN server. The
default port is 3478.
STUN refresh time
Enter the time intervals at which the
phone should repeat the registration
with the STUN server. The repeat is
required so that the entry of the phone
in the tables of the STUN server is
retained. The repeat will be carried out
for all activated VoIP phone numbers.
Ask your VoIP provider for the
STUN refresh time .
The default is 240 seconds.
If you enter 0 seconds, the registration
will not be repeated periodically.
NAT refresh time
Specify the intervals at which you want
the phone to update its entry in the
NAT routing table. Specify an interval in
seconds that is a little smaller than the
NAT session timeout.
As a rule you should not change the
preconfigured value for the NAT refresh
time .
Outbound proxy mode
Specify when the outbound proxy
should be used.
Always
All signalling and voice data sent by the
phone is sent to the outbound proxy.
Auto
Data sent by the phone is only sent to
the outbound proxy when the phone is
connected to a router with symmetric
NAT or blocking firewall. If the phone is
behind an asymmetric NAT, the STUN
server is used.
If you have set STUN enabled = No or
have not entered a STUN server, the
outbound proxy is always used.
Never
The outbound proxy is not used.
If you do not make an entry in the
Out-
bound proxy field, the phone behaves
independently of the selected mode, as
with Never .
Outbound proxy
Enter the (fully qualified) DNS name or
the IP address of your provider's out-
bound proxy.
Outbound proxy port
Enter the number of the communica-
tion port used by the outbound proxy.
The default port is 5060.
Saving settings on phone
¤
Click on Set to save the changes.
The Connections list will be shown after
saving (see Figure 3 on page 77).
If you want to reject the changes that have
been made, click on Cancel . The Web page
is re-loaded with the data saved on the
phone.
Please note: If you do not make any
entries for a lengthy period, the connec-
tion to the Web configurator is automati-
cally terminated. Unsaved entries are lost.
If necessary, implement temporary secu-
rity measures. You can subsequently con-
tinue the entry and make changes if nec-
essary.
Activating new connection
If you have configured a new VoIP connec-
tion, you must also activate it.
In the
Connections list:
¤
Activate the relevant option in the
Active column ( ½ = activated).
Please note:
With many providers, the outbound proxy is
identical to the SIP proxy.