Symbol Technologies SPT 1700 User Manual
Page 33
1-9
Getting Started with the SPT 1700
Note: You may require a 9-pin to 25-pin adapter, p/n 160-0072 to connect
the cable to the serial port on the back of your computer.
Note: Your SPT 1700 terminal requires a dedicated port. It cannot share a
port with an internal modem or other device. If you are unsure about
the location of the serial port on your computer, refer to the user’s
manual supplied with the computer.
4.
Connect the power jack into the power receptacle on the back of the cradle.
5.
Plug the power cable into the wall.
CRD1700-1000M Modem Cradle
To connect the cradle:
1.
Turn off your computer.
2.
Plug the RJ-41 connector of the communication cable into the Line Out port on the
back of the cradle.
3.
Plug the other end of the cable into the serial port on the back of your computer.
4.
Plug one end of the phone cord into the Line In port on the cradle, and the other
end into a wall phone jack.
5.
Connect one end of the power cable into the power port on the back of the cradle,
and plug the other end into a wall outlet.