Symbol Technologies SPT 1700 User Manual
Page 34
1-10
SPT 1700 Series Product Reference Guide
Note: Your SPT 1700 terminal requires a dedicated port. It cannot share a
port with an internal modem or other device. If you are unsure about
the location of the serial port on your computer, refer to the user’s
manual supplied with the computer.
Refer to
Chapter 9, Applications: HotSync®
for instructions on configuring the cradle and
terminal for modem synchronization.
CRD1700-4000E Ethernet Cradle
Before setting up the cradle, make sure that Symbol Palm Terminal Desktop Software (p/n
SW-35138-xx) is installed and running on the host computer, as well as properly configured
Network HotSync software on the SPT 1700 terminal. Refer to the section
on page 1-23 for instructions on installing this software. Specific
software setup necessary to use the CRD1700-4000E is discussed in
A DHCP server must be configured and operational on the subnet to which the cradle will
be attached.
To connect the cradle:
1.
Connect the power supply cable round plug to the power connector on the back of
the cradle.
2.
Connect the power supply AC plug to a standard electrical outlet.
Note: International customers must use a separate AC power cable
appropriate for their respective country.
The cradle’s LEDs blink, then remain off until a terminal is inserted into one or more of the
slots.
DC Power
Connector