Symbol Technologies SPT 1700 - Manual (Page 40)

1-16
SPT 1700 Series Product Reference Guide
2. Slide the flat metal piece into the handstrap connection on the bottom of the
terminal.
3. Adjust the velcro
®
strap to fit your hand.
Starting the SPT 1700
After charging and installing the battery, start the terminal by pressing the red power button
on the front of the unit. If the terminal does not power on, perform a hard reset.
Note: When starting the terminal for the first time, or whenever the battery
is completely drained, a hard reset is required.
To hard-reset the terminal:
1. Remove the battery cover from the back of the terminal.
2. Hold down the power button on the front of the SPT 1700 terminal.
3. While holding down the power button, use the tip of the stylus to gently press the
reset button on the back of the terminal.
4. Release the reset button.
5. Release the power button.
Thread metal piece
through this connector
Slide flat metal piece
up and into this
connector