Symbol Technologies SPT 1700 - Manual (Page 41)

1-17
Getting Started with the SPT 1700
6. When a message displays on the screen warning that you are about to erase all
the data stored on your SPT 1700 terminal, do one of the following:
a. Press the upper half of either of the scroll buttons on the front panel of the SPT
1700 terminal to complete the hard reset and display the Digitizer screen.
b. Press any other button to perform a soft reset.
Note: With a hard reset, the current date and time are retained. Formats
Preferences and other settings are restored to their factory default
settings.
After initial start up, always start the terminal by pressing the red power button.
Calibrating the Screen
The first time you start your SPT 1700 (or after a hard reset), the calibration screen
displays. Follow the steps in this section to align the internal circuitry of your SPT 1700 with
its touch-sensitive screen.
Note: If your SPT 1700 unit came pre-loaded with a custom software
application, you may not need to calibrate your screen, in which
case you will not see the calibration screen.
To calibrate your SPT 1700 for first time use:
1. Press the power button on the front panel of your SPT 1700 to display the
calibration screen. (This screen also displays following a hard reset).
2. Remove the stylus from its storage silo on the back of the SPT 1700.
Power
Button