Socket Mobile Digital Phone Card for Data-Capable Mobile Phone - Manual (Page 29)

CHAPTER 4: CASIO BE-300 SETUP | 27
STEP 6: Make a Data Call
Preliminary Checklist
# Is the card properly inserted into your mobile computer, and is the cable
connected securely to your mobile phone?
# Is the phone receiving a digital signal? A or equivalent will appear on
the display of some phones.
# Is the mobile phone’s signal strength sufficient? A minimum strength of
two bars is recommended, but some phones can send data with one. For
a better signal, raise the antenna, hold the phone upright, and/or relocate.
# Does your phone have enough battery power for your data call?
Placing a Data Call
1. After setting up the network connection in Step 5, the DPC connection
should be listed in the Connections screen. Select your DPC connection,
then tap Connect.
2. In the Dial-up Connect screen, verify the phone number, then tap
Connect.
3. A series of screens will appear, reporting the status of your call. When
your BE-300 has connected, it will report Connected.
Ending a Data Call
1. If you hid the connection status screen, tap on the connection icon
in the status bar to make it re-appear.
2. In the connection status screen, tap Disconnect. In the next screen, tap
Disconnect Now.