Kane Industries C6713CPU - Manual (Page 23)

H ARDWARE R EFERENCE G UIDE
MICRO - LINE
®
C6713CPU
Date : 28 November 2005
Doc. no. : C6713CPU_HRG
Iss./Rev : 1.1
Page : 23
3.8 EMIF Configuration
All accesses to off-DSP-chip peripherals, such as on-board SDRAM, the UART or the FPGA are
performed by the DSP's external memory interface (EMIF). The timings and interface type for
these accesses can be software-programmed separately for each CE space (see Table 2 for an
overview of the CE space usage).
3.8.1 Default EMIF configuration
When the C6713CPU is reset or powered on, it automatically boots the Flash File System, which
initializes the EMIF to a safe timing. This timing can be used for many applications, so that no
further EMIF initialization is necessarily required. However, I/O performance can be optimized by
application software by faster accesses to the FPGA and off-board peripherals. This can be done
by modifying the timing settings for the CE2 and CE3 address spaces. Examples for this can be
found in the software examples that are shipped with the C6713CPU.
CE space configuration register
32 bit initialization value
CE2 32B3 8A23
CE3 32B3 8A13
Table 3: default initialization values for the FPGA related CE space registers 1
Parameter
Value Timing for an EMIF clock of 100MHz
bus width 32 bit n/a
Read set-up time 3 EMIF clocks 30 ns
Read strobe time 10 EMIF clocks 100 ns
Read hold time 3 EMIF clocks 30 ns
Read/write turnaround time 2 EMIF clocks 20 ns
Write set-up time 3 EMIF clocks 30 ns
Write strobe time 10 EMIF clocks 100 ns
Write hold time 3 EMIF clocks 30 ns
Table 4: CE2 default configuration
Parameter Value Timing for an EMIF clock of 90MHz
bus width 16 bit n/a
Read set-up time 3 EMIF clocks 30 ns
Read strobe time 10 EMIF clocks 100 ns
Read hold time 3 EMIF clocks 30 ns
Read/write turnaround time 2 EMIF clocks 20 ns
Write set-up time 3 EMIF clocks 30 ns
Write strobe time 10 EMIF clocks 100 ns
Write hold time 3 EMIF clocks 30 ns
Table 5: CE3 default configuration
3.9 Description of the PLD Board Registers
The PLD board registers are mapped into the DSP's CE1 address space. Table 6 lists the address
map of all board registers. The register mnemonics are used in this documentation as well as in
the software that is shipped together with the board.
1 These initialization values are only valid for an EMIF clock setting of 90MHz. If another EMIF
clock is used, these settings may be different.