Logicube Omniclone Xi - Manual (Page 13)

Logicube Omniclone Xi ™ User’s Manual 7
2. Getting Started (Fast Start)
Applying power to the Logicube Omniclone Xi™
The Logicube Omniclone Xi™ is able to detect
whether an IDE (parallel) or Serial ATA (SATA) drive
is attached to the Master or Target positions. The unit
is capable of cloning to/from a SATA drive to an IDE
drive and vice versa (as well as IDE to IDE and SATA
to SATA).
NOTE: Never attach both an IDE and SATA drive to
the same drive position. The unit can only handle one
drive on each position.
Before applying power perform the steps listed below.
Connecting Parallel (IDE, EIDE, UDMA) Drives
1. Locate the Master position on the top of your
Omniclone-Xi™ unit. You will notice three
connections: One for a flat cable (the drive data
cable) and another for a small drive power
cable. Above is the third connector for the
Serial ATA cable.
Note: The drive that is cloned from is always
referred to as the Master drive and the drives that
are cloned to are always referred to as the Target
drives.
2. Attach the 5” UDMA ribbon cable and the drive
Power cable to the connectors.
3. Connect the Master hard drive to the cables
and verify that the drive’s jumper is set to Single
Master.
4. Follow steps 1 – 3 to attach drives to the Target
positions of the Logicube Omniclone Xi™.
5. Connect the AC Power Cord to the back of the
Logicube Omniclone Xi™ and power-up the