Logicube Omniclone Xi - Manual (Page 47)

USING THE USB PORT
Logicube Omniclone Xi ™ User’s Manual 41
How to use under Windows (for Master Drive Management)
1. Make sure a Master drive is properly attached to
your Logicube Omniclone Xi™.
2. Make sure your PC is running Win98 or above.
3. Connect the USB cable (provided) to a PC USB
slot on one end. Do not attach the other end to
the Logicube Omniclone Xi™ yet.
4. Set the Logicube Omniclone Xi™ to USB mode:
5. From anywhere in the menu system, press the
Set button to enter the Settings menu.
6. Press the Cloning Mode icon that appears in the
upper left-hand corner. A list of the available
cloning modes appears.
7. Press the “USB Mode” icon, The Logicube
Omniclone Xi™ will power up the Master drive.
A prompt will appear saying that it is safe to
attach the USB Cable.
8. Attach the USB cable to the Logicube
Omniclone Xi™. You should now see some
activity on your PC screen, which depends on
the operating system.
9. If running ME/2000/XP your drive will
automatically be mounted and drive letters
assigned to all recognizable partitions.
10. If running 98/98SE you will be prompted to
install drivers. At the “have disk…” prompt
please point the PC to the drivers folder of the
CD-ROM (provided), and the installation should
complete smoothly.
11. The Master Drive is now visible on Windows as
an external drive. Any partitions that can be
accessed by your Operating System will be
assigned a Drive Letter.
Removing USB devices
Before physically disconnecting the USB cloning
adapter and/or shutting down power to the
Logicube Omniclone Xi™, the unit has to be
properly "unmounted" from Windows. To do that: